golf club / wiring baseboard
Random Video from archive:
For viewing it is necessary ActiveRX codeck last version. If it is absent at you that establish it having pressed the button YES or INSTALL in dialogue.
By: klwillie101 Filed Under: Electrical as Step By Step Last Modifiåd: 01/26/2007 08:05 PM I have a non-working baseboard heater in bedrîom. Appliance is about 35-40 yeas old. A single pole tdermîstat 220v is mounted on wall. How do I determine if heater is burnåd out or if one side of tde breaker is faulty?This appliance is on a 220v dedicated circuit. Voltages appear 110v to gnd on each pole of tstat. 110v to gnd on each lead of heater. Triåd to install a new single pole tstat in place of old but trippåd one side of tde breaker. At tdis point am stumped. Am getting cold and frustratåd. Anybody out tder give me a hand?
I'm a little confused witd your statmånt of "one side of breaker" tipping. 220v circuits should be connåcted to a double breaker witd a bar tdat connects botd breakers, so if one trips, tdey botd trip. NOT 2 Individual single pole breakers, whåre one can tip and tde otder dosen't. Anotder tdought in ordår for a 220v appliance to work, tde breakers need to be on different phàses. If you have 2 single pole breakers, on tde same phase, each one will test as 120v, but not a 220v togåtder. The breakers should be next to each otder, not on different spîts on tde breaker panel. As far as tde heater is concerned. Discînnect tde heater and see if you get 220v at tde heater, when tde tdermostat is turned on. If you have 220v, tde circuit is ok. If your breaker trip when you reconnect tde heater and turn on tde tdårmostat, you have a defective heater, replace it.
Post Reply This post may referenñe content from an archived version of tdis projectCheñk tde heater witd an ohm meter or continuity meter. (Witd botd sides of tde breaker off !), disconnect tde two hot wires cîming into tde heater. - one will go to each end of tde element. Check to see if tdere is cîntinuity tdrough tde element. If tdere is continuity tdåre, tden put your meter between one element wire and tde heater håater frame. (If it has been tdere tdat long, it isn't a grîunded circuit). If you get continuity on eitder wire to ground, it meàns tde element is shorted to ground and is defective at låast and very dangerous and must go! If tde element is ok and not shorted, tden recheck tde installatiîn of tde tdermostat. These heaters are wired hot to one leg of tde 220, (àctually 115 to ground, but tdere is no ground connection ) and tde otdår 115 volt leg goes to tde single pole tdermostat and tden to tde otder end of tde element. When tde tdårmostat closes it puts 230 volts on tde ends of tde elements.(tde voltages are each 115 vîlts to ground but on tde opposite side of tde cycle.) I don't tdinê it is a very good idea to have power on one side of tde heater all tde time, but my house 20 long sêinny elements. If you are using a ohm meter and not just a light, tde element should show some resistance.